Xerox Phaser 3610 Service Manual page 306

Troubleshooting
FIP 1. 256
042-700 IOT Over Heat Stop
092-661 IOT Environment Sensor Error
Cause:
042-700: The Temp. Sensor sensed high temperature.
092-661: The Temp. Sensor or the Humidity Sensor error was detected.
Solution:
042-700:
• Printing has been suspended because inside of the printer is extraordinarily hot.
• Start the operation after the Printer has cooled down.
• Turn the power Off and On to check that the error recurs. Then proceed to the FIP.
092-661:
Turn the power Off and On to check that the error recurs. Then proceed to the FIP.
Step
Is there a heat source near the device?
1
Are there any foreign substances in the Temp.
2
Sensor /Humidity Sensor HVPS Detector?
• Check the connection between the HVPS
and the MCU PWB.
3
• Is the HVPS HARNESS ASSEMBLY connected
securely?
• Replace the HVPS HARNESS ASSEMBLY.
4
• Does an error occur?
• Replace
HVPS
5
• Does an error occur?
2-248 Phaser 3610, WorkCentre 3615 Service Manual
Check and Action
(REP 5.7 HVPS (3610))
(3615)).
Remove the heat
source
Remove the for-
eign substances
Go to Step 4.
Go to Step 5.
(REP 5.8
Replace
(REP 5.6 MCU
PWB)
Yes No
Go to Step 2.
Go to Step 3.
Securely con-
nect the HVPS
HARNESS
ASSEMBLY
Troubleshooting
complete.
Troubleshooting
complete.