Xerox Phaser 3610 Service Manual page 453

IQ-19 Skewed Image
Troubleshooting Reference
Applicable Parts
• IIT Assembly, PL 6.1
• DADF Assembly, PL 6.1
• DADF Pick Up Module, PL 6.1
• Rubber Roll Assembly, PL 2.2
• Regi Pinch Roll Assembly, PL 2.2
• Regi Pinch Roll, PL 2.2
• Transfer Roller Assembly, PL 3.4
• Fusing Assembly, PL 3.5
Note: for the Phaser 3610, begin the procedure at step 7.
Troubleshooting Procedure
Step Actions and Questions
1 Does the error occur only during copying?
Does the error occur when feeding the original at
2
the DADF?
Is the original positioned on the Platen Glass cor-
3
rectly?
4 Does the original meet the DADF spec?
Reseat the DADF Guides.
5
Does the error still occur when copying?
Are there any damages or foreign substances on
6
the DADF Pick Up Module?
7 Is the skewed paper fed from the MSI?
Reset the MSI side guides.
8
Is the image printed correctly?
Are there any foreign substances on the paper
9
path?
Example Print
Yes
Go to step 2.
Go to step 4.
Replace (REP 6.1 IIT
Assembly).
Go to step 5.
Go to step 6.
Remove the foreign
substances or replace
REP 5.6 MCU PWB
(
Go to step 8.
Troubleshooting
complete.
Remove the foreign
substances, then go to
step 10.
Phaser 3610, WorkCentre 3615 Service Manual
Image Quality
No
Go to step 7.
Go to step 3.
Reseat the original.
Use the platen mode
or change the paper
type.
Troubleshooting
complete.
Replace (REP 6.2
DADF).
).
Go to step 9.
Go to step 9.
Go to step 11.
3-43