Xerox Phaser 3610 Service Manual page 380

Troubleshooting
FIP 2.09
Invert Clutch Assembly
Cause:
Parts to be considered:
• DRIVE EXIT OUT HOLDER ASSEMBLY
• DRIVE EXIT IN HOLDER ASSEMBLY
• INVERT CLUTCH ASSEMBLY
• MCU PWB
Solution:
Step
Are there any foreign substances in the
INVERT CLUTCH ASSEMBLY Drive Sec-
1
tion?
Is the DRIVE EXIT OUT HOLDER ASSEM-
BLY or the DRIVE EXIT IN HOLDER
2
ASSEMBLY damaged?
Check the connection between the
INVERT CLUTCH ASSEMBLY and the
MCU PWB.
3
• Is the INVERT CLUTCH ASSEMBLY
(P/J17) connected securely?
• Replace the INVERT CLUTCH
ASSEMBLY.
4
• Does an error occur?
2-322 Phaser 3610, WorkCentre 3615 Service Manual
(PL 4.1
(PL 5.3 Electrical (MCU PWB /
Check and Action
(PL 4.1 Drive)
(PL 4.1 Drive)
Drive)
HVPS))
Yes
Remove the foreign
substances
Replace the DRIVE
EXIT OUT HOLDER
ASSEMBLY and the
DRIVE EXIT IN
HOLDER ASSEMBLY
Go to Step 4.
Replace
(REP 5.6 MCU
No
Go to Step 2.
Go to Step 3.
Securely connect
the INVERT-
CLUTCH ASSEM-
BLY
Troubleshooting
complete.
PWB)