Xerox Phaser 3610 Service Manual page 465

Precautions
• Only replace parts that are provided by the parts unit. Do not remove and replace any parts other
than those provided parts. Never break down the provided parts or replace the parts that have
been removed. Replacing any parts other than the provided parts will not guaranteed quality or
safety, and is strictly forbidden.
• When a harness wiring is removed for service work, make sure that the harness wiring goes
through the same route as before. Check that the harness is set into the harness guides properly
before proceeding with the procedure. Check that the harness is not trapped when an assembly is
replaced, or a cover is closed. There is no unnecessary slack found in any harness so proper re-
routing of a harness is crucial.
Before starting service work note the following:
• Start the procedure after turning off the power and removing the power cord from the outlet.
• Wear an anti-static wrist band when performing the removal of any PWBs or electrical circuits.
• When performing the service operation around the Fusing Assembly, ensure that the Fusing
Assembly and its surrounding area have cooled down sufficiently.
• Pay sufficient attention to the parts removed during a procedure because they may be broken or
may cease to function properly if unreasonable force is applied.
• Put the removed parts, such as Toner Cartridge in a dark place where it will not affect the service
procedures. (Note that the service procedures can be performed with those parts in place
depending on the target section of removal/replacement.)
• Since various types of screws are used, ensure that the right screws are used in their right
positions. Use special caution not to confuse the screws for plastic and the ones for sheet metal,
because using the wrong type of screws may result in damage to the screw threads or other
troubles.
• When releasing tabs or bosses, it may be best to use a small flat-head screwdriver to assist in the
disassembly, by gently prying the intended areas apart.
Phaser 3610, WorkCentre 3615 Service Manual
Service Parts Disassembly
4-3