Xerox Phaser 3610 Service Manual page 408

Troubleshooting
Precautions and Limitations
The following describes the precautions and limitations for TCP/IP (LPD).
Machine Settings
• IP Addresses are managed in a whole system. Consult with the Network Administrator
thoroughly before perform setting.
• Depending on the network environment, perform the sub net mask and gateway
settings if necessary. Consult with the Network Administrator to set necessary settings.
• If a memory becomes insufficient when Enabled is set for the port status, the port status
may be automatically reset to Disabled. In this case, set Disabled for unused ports or
change the memory allocated capacity.
• Depending on the usage environment, set the receiving buffer capacity lpd (Spool) size.
When the receiving buffer capacity lpd (Spool) size is smaller than the sent data, it may
not be able to be received.
Computer Settings
• IP Addresses are managed in a whole system. Consult with the Network Administrator
thoroughly before perform setting.
• To perform network settings (such as IP Address), etc. on the host used under NIS
(Network Information Service) management, consult with the NIS Administrator.
At Power OFF
Before turning the machine OFF, take note of the following:
• When Memory is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine memory will be deleted. When the power is turned ON again, no print data
remains.
However, if the power is turned OFF immediately after the print instruction, the print
data may be stored on the computer. In this case, even if a new print instruction is issued
after the power is turned ON, the stored print data will be printed first.
• When Hard Disk is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine hard disk will be saved. When the power is turned ON again and a new print
instruction is issued, the stored print data will be printed first.
• When No Spooling is set for lpd (Spool)
All the print data including the data being printed that have been spooled in the
machine receiving buffer will be deleted. When the power is turned ON again, no print
data remains.
However, if the power is turned OFF immediately after the print instruction, the print
data may be stored on the computer. In this case, even if a new print instruction is issued
after the power is turned ON, the stored print data will be printed first.
2-350 Phaser 3610, WorkCentre 3615 Service Manual