Switch-On And Switch-Off Functions For Operation As An Output; Input Functions For Operation As An Input - Leuze electronic BCL 248i Operating Instructions Manual

Starting up the device - Configuration

8.12.3 Switch-on and switch-off functions for operation as an output

The following options are available for switch-on and switch-off functions in the "output" operating mode:
Tab. 8.38: Switch-on/switch-off functions
Name
No function
Reading gate start
Reading gate end
Positive reference code comparison 1
Negative reference code comparison 1 4
Valid read result
Invalid read result
Device ready
Device not ready
Data transmission active
Data transmission not active
AutoControl good quality
AutoControl bad quality
Reflector detected
Reflector not detected
External event, pos. edge
External event, neg. edge
Device active
Device in standby mode
No device error
Device error
Positive reference code comparison 2
Negative reference code comparison 2 24

8.12.4 Input functions for operation as an input

Tab. 8.39: Input functions
Name
No function
Reading gate activation
Reading gate deactivation only
Reading gate activation only
Reference bar code teach-in
Start/stop AutoConfiguration mode
Leuze electronic GmbH + Co. KG
Value Comment
0 No functionality
1
2
3
5
6
7 The device is in a ready state.
8 The device is not yet ready (motor and laser are being acti-
vated).
9
10
13
14
15
16
17 In the PROFINET case, the external event is generated
with the aid of module 74 – "I/O status and control", see
chapter 8.12.7 "Module 74 – SWIO status and control".
18 See above
19 Decoding is currently being performed.
20 Motor and laser inactive.
21 An error was detected.
22 Device is in an error state.
23
Value
0
1
2
3
4
5
BCL 248i
Comment
No functionality
89