Table of Contents
Advertisement
Starting up the device - Configuration
8.4.2
Permanently defined parameters/device parameters
On the PROFINET-IO, parameters may be stored in modules or may be defined permanently in a
PROFINET-IO participant.
Depending on the configuration tool, the permanently defined parameters are called "common" parameters
or device-specific parameters.
These parameters must always be present. They are defined outside configuration modules and are thus
connected to the base module (DAP: Device Access Point) that is addressed via Slot 0/Subslot 0
In SIMATIC Manager, the permanently defined parameters are set via object properties of the device. The
module parameters are configured via the module list of the selected device. By selecting the project prop-
erties of a module, the respective parameters may be set if required.
The following list contains the device parameters that are permanently defined in the BCL 248i (DAP Slot 0/
Subslot 0) but are configurable. These parameters always exist and are available independent of the mod-
ules.
Tab. 8.1:
Device parameters
Parameter
Profile num-
ber
Code type 1
Number of
digits mode
Number of
digits 1
Number of
digits 2
Number of
digits 3
Leuze electronic GmbH + Co. KG
Description
Number of the activated pro-
file, for BCL 248i constant
with the value 0.
Released code type; no code
means that all subsequent
code tables are also deacti-
vated.
The valid number of digits
also depends on the code
type.
Interpretation of the number
of digits
Decodable number of digits;
in the case of a range, this
number defines the lower
limit.
Specifying a 0 for the num-
ber of digits means that this
entry is ignored for the de-
vice.
Decodable number of digits;
in the case of a range, this
number defines the upper
limit.
Decodable number of digits
in the enumeration mode.
Address
Data type
0
UNSIGNED8 0 ... 255
1.0 ... 1.5 BitArea
2.6
Bit
2.0 ... 2.5 UNSIGNED8 0 ... 63
3
UNSIGNED8 0 ... 63
4
UNSIGNED8 0 ... 63
BCL 248i
Value range
Default
0
0: No code
1
1: 2/5 Interleaved
2: Code39
3: Code32
6: UPC, UPCE
7: EAN8, EAN13
8: Code128
10: EAN Addendum
11: Codabar
12: Code93
13: GS1 DataBar
OMNIDIRECTIONAL
14: GS1 DataBar
LIMITED
15: GS1 DataBar EX-
PANDED
0: Enumeration
0
1 : Range
10
0
0
48
Advertisement
Table of Contents
