Leuze electronic BCL 248i Operating Instructions Manual page 62

Starting up the device - Configuration
Parameter
Reading gate
end mode/com-
pleteness mode
Restart delay
Max. reading
gate time when
scanning
1) see chapter 8.7.3 "Module 12 – Multi-label"
2) Corresponds to the settings carried out via the device module (see chapter 8.4.2 "Permanently defined
parameters/device parameters") or module 1-4 – Code table extensions 1 to 4.
3) see chapter 8.10 "Identifier", modules 52-54 "identifier filter string"
4) see chapter 8.14.3 "Module 83 – Reference code comparison pattern 1" and see chapter 8.14.4 "Module
84 – Reference code comparison pattern 2"
Parameter length
6 bytes
Input data
None
Output data
None
Leuze electronic GmbH + Co. KG
Description
This parameter can be used
to configure the complete-
ness inspection.
The parameter specifies a
time after which a reading
gate is restarted. The
BCL 248i generates its own
periodic reading gate. The
configured time is active only
if the automatic reading gate
repeat is switched on.
The parameter switches off
the reading gate after the set
time has elapsed, thus limit-
ing the reading gate to the
set period.
Addr. Data type
1 Byte
2 UN-
SIGNED16
4 UN-
SIGNED16
BCL 248i
Value range
0: Independent of de-
coding, i.e., the reading
gate is not terminated
prematurely.
1: Dependent on decod-
ing, i.e, the reading gate
is terminated if the con-
figured number of bar
codes to be decoded
has been reached. 1)
2: DigitRef table-depen-
dent, i.e., the reading
gate is terminated if
each bar code stored in
the code type table has
been decoded. 2)
3: Ident list dependent,
i.e., the reading gate is
terminated if each iden-
tifier stored in a list
could be segmented via
a respective bar code
segmentation. 3)
4: Reference code com-
parison, i.e., the reading
gate is terminated if a
positive reference code
comparison has taken
place. 4)
0 ... 65535 ms
1 ... 65535 ms
0: Reading gate activa-
tion is switched off
Default
1
0 ms
0 ms
62