NEC Xen Topaz Features And Specifications Manual page 85

Hide thumbs Also See for Xen Topaz:
Table of Contents

Advertisement

XEN Topaz
• Related Features
• Programming
Features and Specifications Manual
Call Forwarding, Fixed
Fixed Call Forwarding can automatically forward an extensions calls to an outside
number.
Call Forward to Abbreviated Dial
Call forward codes can be used to forward to abbreviated dial that will route off
premise.
Doorphone
Doorphones must be programmed in order for the calls to be transferred off-
premise.
Toll Restriction
The outside number OPX Call Forwarding dials can only be a number normally
allowed by the forwarded extension's Toll Restriction.
Voice Response System (VRS)
In systems with a DSP daughter board for VRS, callers to an extension forwarded
off-premise hear, "Please hold on, your call is being rerouted."
11-10-04: Service Code Setup (for System Administrator) - Storing Common
Abbreviated Dialling Numbers.
Assign the service code to be used for Common Abbreviated Dialling
(853 by default).
11-10-18: Service Code Setup (for System Administrator) - Off-Premise Call
Forward by Doorphone
Assign the service code to be used for Off-Premise Calling Forwarding
by a Doorphone (822 by default).
14-01-13: Basic Trunk Data Setup - Loop Supervision
Enable (1) loop supervision for each trunk that should be able to use
Call Forwarding Off-Premise.
14-02-08: Analogue Trunk Data Setup – Answering Condition
All analogue trunks involved in Call Forward Off Premise must be
assigned with Polarity Reversal (Line Reversal on Answer).
14-02-12: Detect Network Disconnect Signal
Enable the network disconnect signal detection for proper release of
analogue trunks.
14-02-13: Trunk to Trunk Limitation
When 14-02-12=1 (enabled) and 14-02-13=0 (disabled),
Trunk to Trunk Transfer/Call Forward Off-Premise uses the following dis-
connect timers:
25-07-07 (DISA Conversation Warning Tone Time)
25-07-08 DISA Long Conversation Disconnect)
When 14-02-12=1 (enabled) and 14-02-13=1(enabled),
Trunk to Trunk Transfer/Call Forward Off-Premise uses the following dis-
connect timer:
24-02-07 (Forced Release Timer for Trunk to Trunk Transfer)
NEC Business Solutions Ltd
Chapter 4 - 77

Advertisement

Table of Contents
loading

Table of Contents