NEC Xen Topaz Features And Specifications Manual page 113

XEN Topaz
• Related Features
Features and Specifications Manual
Assign a CODEC Gain Type to each trunk. This sets the amount of gain
(amplification) for the selected trunk.
14-01-07: Basic Trunk Data Setup - Outgoing Calls
For each trunk, allow (1) or prevent (0) outgoing calls.
14-01-10: Basic Trunk Data Setup - DTMF Tones for Outgoing Calls
For each trunk, enable (1) or disable (0) DTMF tones for outgoing trunk
calls.
14-07-01: Trunk Access Map Setup
Set up the Trunk Access Maps (1-51). This sets the access options for
trunks.
15-06-01: Trunk Access Map for Extensions
Assign Trunk Access Maps (1-51) to extensions.
15-07-01: Programming Function Keys
To simplify placing calls, assign function keys for placing trunk calls: Line
keys (1-51) and Trunk Group/loop keys (code *02 + group).
20-02-06: System Options for Multi-Line Telephones – Pre-selection Time
Set the preselection interval (0-64800 seconds). When a system phone
user preselects a line key, the system remembers the preselection for
this interval.
20-02-09: System Options for Multi-Line Telephones - Disconnect Supervi-
sion
Enable (1) disconnect supervision for the system.
20-06-01: Class of Service for Extensions
Assign a Class Of Service (1-15) to extensions.
20-08-02: Class of Service Options (Outgoing Call Service) - Trunk Calls
In an extension's Class of Service, enable (1) or disable (0) trunk calling.
21-15-01: Alternate Trunk Route for Extensions
Designate the trunk route accessed when a user dials the Alternate
Trunk Route Access Code. Refer to "Trunk Group Routing" to set up out-
bound routing.
81-01-01: Analogue Trunk Data Setup
Review the Analogue Trunk Timers for compatibility with the connected
telco.
• Alphanumeric Display/Call Timer
If the trunk name seize display is enabled in programming (Program 20-09-04=1)
, Call Timer starts automatically after the user places a trunk call. Disabling the
trunk name seize display (Program 20-09-04=0) also disables the Call Timer.
• Automatic Route Selection
The system can automatically select the correct type of line to use based on the
number dialled and the time.
• Handsfree
NEC Business Solutions Ltd
Chapter 4 - 105