NEC Xen Topaz Features And Specifications Manual page 156

NEC Business Solutions Ltd
If VRS facility (DSPDB Unit) is available:
Chapter 4 - 148
Assign each DIL Service Type 4. Make an entry for each Night Service
mode.
22-04-01: Incoming Extension Ring Group Assignment
Assign the extensions that should receive the overflow to the ring group
programmed in 2208. Set the ringing in Program 22-06 (0=trunks don't
ring [just flash line keys], 1=trunks ring).
22-07-01: DIL Assignment
Set the destination extension port for each DIL - for each Night Service
mode. The destination can be an extension port, virtual extension port,
or Department Group.
22-08-01: DIL/IRG No Answer Destination
For each DIL with delayed ringing, enter the DIL No Answer Ring Group.
An unanswered DIL rings this group after the DIL No Answer Time.
Make an entry for each Night Service mode (Ring Group (1-25) or
DSPDB Voice Mail=101).
22-11-11 :DID Translation Number Conversion, Ring Group Transfer
Enable (1) or disable (0) each conversation tables' ability to follow the
Ring Group programming defined in Program 22-12-01 : DID Intercept
Ring Group. If Program 22-11-05 : DID Translation Number Conversion,
Transfer Destination Number 1 and Program 22-11-06 : DID Translation
Number Conversion, Transfer Destination Number 2 are set, the priority
of transferring will be in this order: Program 22-11-05 then Program 22-
11-06 then if Program 22-11-11 is enabled, Program 22-12-01.
25-01-01 :DID/DISA Line Basic Data Setup - DID/DISA Dial-In Mode
Determine whether the system should use option 0 (Extension number/
Service code specify) or option 1 (Use dial conversion table) for calls.
25-01-03 :DID/DISA Line Basic Data Setup - DID/DISA Transfer Alarm
Determine whether the system should use option 0 (Normal) or option 1
(Alarm) for calls.
25-02-01 :DID/DISA VRS Message
For each DID/DISA trunk port (1-51) and each night mode (1-8), select
the message source (0=No Message, 1=VRS, 2=ACI, 3=SLT) and
assign the VRS message number to be used as the Automated Atten-
dant Message for each trunk which is assigned as a DID/DISA (Addi-
tional data required with VRS=01-48 [VRS message number], with
ACI=1-4 [ACI group number], and with SLT=1-32 [Station group number]
).
25-03-01 :DID/DISA Transfer Ring Group With Incorrect Dialling
For each trunk port (1-51), set what happens to a call when the DISA or
Automated Attendant caller dials incorrectly or waits too long to dial. The
call can either disconnect (0) or Transfer to an alternate destination
(Ring Group=1-25 or DSPDB Voice Mail=101). When setting the DISA
and DID Operating Mode, you make an entry for each Night Service
mode (1-8).
25-04-01 :DID/DISA Transfer Ring Group With No Answer/Busy
XEN Topaz
Features