NEC Xen Topaz Features And Specifications Manual page 157

XEN Topaz
Features and Specifications Manual
For each trunk port (1-51), set the operating mode of each DISA trunk.
This sets what happens to the call when the DISA or Automated Atten-
dant caller calls a busy or unanswered extension. The call can either
disconnect (0) or Transfer to an alternate destination (Ring Group=1-25
or DSPDB Voice Mail=101). When setting the DISA and DID Operating
Mode, you make an entry for each Night Service mode (1-8).
25-05-01 :DID/DISA Error Message Assignment
For each trunk that will be answered by the VRS, enter the VRS mes-
sage number (1-48) the outside caller hears if they dial incorrectly after
answer. If you enter 0, the call reroutes according to Program 25-03 and
Program 25-04. Make one entry for each Night Service mode.
25-06-02 :DID/DISA One-Digit Code Attendant Setup
Set up single digit dialling for Automated Attendant callers. For each
VRS Message programmed to answer outside calls, specify:
- The digit the Automated Attendant caller dials (0-9, *, #). (Keep in mind
that if you assign destinations to digits used for extension numbers, out-
side callers will not be able to dial system extensions.)
- The destination reached (four digits maximum) when the caller dials
the single digit code.
25-07-01 :System Timers for DID/DISA - VRS Dial Tone Time
After answering a DID/DISA trunk, the system waits this interval for the
caller to dial the first digit of the DISA password. If the caller fails to dial
within this interval, the system drops the call (0-64800).
25-07-02 :System Timers for DID/DISA - DID/DISA No Answer Time
A DID/DISA caller can ring an extension for this interval before the sys-
tem sets the call as a Ring No Answer. After this interval expires, the call
follows the programmed Ring No Answer routing (set in Program 25-03
and 25-04) (0-64800).
25-07-04 :System Timers for DID/DISA - Calling Time to Automatic Answer-
ing Telephone Set
Set the answering waiting time of the automatic answering extension
when an incoming DID trunk call is received (0-64800).
25-07-05 :System Timers for DID/DISA - Duration Time for Guidance Mes-
sage by Automatic Answering Telephone Set
Set the announcement time of the automatic answering extension after
which in incoming DID trunk caller is disconnected (0-64800).
25-07-06 :System Timers for DID/DISA - Duration Time for Guidance Mes-
sage by ACI
Set the announcement time by the ACI after which an incoming DID
trunk caller is disconnected (0-64800).
25-07-11 :System Timers for DID/DISA - DID/DISA Answer Delay Timer
Set up the interval time the system will wait after receiving an incoming
DID/DISA call until the system will automatically answer the call (0-
64800).
25-07-13 :System Timers for DID/DISA - DID/DISA Busy Tone Interval
NEC Business Solutions Ltd
Chapter 4 - 149