Qiagen QIAcuity 911000 User Manual page 243

To view the mean values for replicates on the diagram, click Show mean values for replicates.
When this checkbox is checked, the concentration diagram shows bars that represents mean
concentration value for replicates within the well selection. The label below the bar shows well
positions that are included in the replicates value of mean concentration. On hover on the bar,
there is a tooltip with details about wells, sample and target that are part of replicate group and
the results are shown as mean result values with a corresponding mean-label. This is also applied
in same way by default to the view where targets are in different reaction mixes. In this case
individual replicate results are not available. When selected well has no replicates within all
selected wells, individual result values are shown.
Note: If the selected analysis source contains replicates of the reference sample, your results can be
calculated only by using mean results for replicates. In this case the "Show mean values for
replicates" check box is marked and can't be changed. In this case there is a warning message
above the diagram title and when the user hover on the checkbox, a tooltip appears to inform the
user that selected analysis source contains replicates of the reference sample and result is calculated
only by using mean results for replicates.
To add the concentration diagram to the report, click Add to report. For more information on reports,
see section Reports.
QIAcuity User Manual 06/2022 243