Figure 57: Lowering The Power Cord Retaining Clip; Figure 58: Connecting The Power Cord To An Ac Power Source - Allied Telesis x320 Series Installation Manual

Figure 57. Lowering the Power Cord Retaining Clip
4. Connect the power cord to an appropriate AC power source. Refer to
Figure 58.
Figure 58. Connecting the Power Cord to an AC Power Source
Note
The illustration shows a North American power cord. Your power
cord may be different.
5. Repeat this procedure to power on additional power supplies.
6. To monitor the switch as it initializes the management software, go to
"Monitoring the Initialization Processes" on page 99. Otherwise, go to
"Starting a Local Management Session" on page 100.
x320 Series Installation Guide
98