Table of Contents
Advertisement
Figure 55. Connecting the Power Cord to an AC Power Source
Note
The illustration shows the North American power cord. Your power
cord may be different.
Note
The power cords included with SBxPWRSYS2 Power Supplies for
100-125 VAC installations have 20 Amp, 125 V NEMA 5-20P plugs.
The plugs require NEMA 5-20R receptacles. Refer to Figure 15 on
page 53.
4. If the switch has two power supplies, repeat this procedure to connect
a power cord to the second power supply.
5. Do one of the following:
To monitor the switch as it initializes the management software, go
to "Monitoring the Initialization Processes" on page 121.
Wait three minutes for the switch to initialize its management
software. Afterwards, go to Chapter 5, "Verifying the Hardware
Operations" on page 125.
SBx908 GEN2 Installation Guide for Stand-alone Switches
93
Advertisement
Table of Contents
