Powering On The Switch; Figure 59: Installing The Power Cord Retaining Clip; Figure 60: Connecting The Ac Power Cord - Allied Telesis CentreCOM GS970EMX/52 Installation Manual

Chapter 8: Displaying the Hardware Status and AlliedWare Plus Version Number

Powering On the Switch

110
The illustrations in this procedure show the North American power cord.
Your power cord may look different. For AC power specifications, refer to
"Power Specifications" on page 169.
Warning
Power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord.  E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible.  E5
To power on the switch, perform the following procedure:
1. Install the power cord retaining clip on the AC power connector on the
back panel of the switch. Refer to Figure 59.
Figure 59. Installing the Power Cord Retaining Clip
2. Raise the retaining clip and connect the AC power cord to the AC
power connector. Refer to Figure 60.
Figure 60. Connecting the AC Power Cord