Mitsubishi Electric MELDAS C6 Instruction Manual page 90

(Refer to "2.3 (II). Tool Offset
(M system)" for M system.
(2) Executing the manual numerical command ..... Carry out this step after (1) above.
(Note)
(3) Operation for returning the mode from the manual numerical command mode to the normal
Press the
setting mode returns.
1) The cursor appears in the first set of
parentheses, and the normal setting mode is
enabled.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
1) Press the address key corresponding to the command. The display area of the
corresponding command value is highlighted, and a manual numerical command input
status results. Execute tool function commands with
commands with M .
2) Key-input the numerical value to be commanded.
INPUT
3) Press the key. The command is executed.
The manual numerical command operation is the same as the operation on the POSITION
screen. Refer to the section on manual numerical commands for the MONITOR and
POSITION screens for details.
data setting mode
key. The normal data
search engine
2.3 (I). Tool Offset (L system)
I - 75
T
, and miscellaneous function