Mitsubishi Electric MELDAS C6 Instruction Manual page 498

Error No.
P603
P604
P605
P606
P607
P608
P610
P990
Downloaded from ManualsNet.com
Details
SKIP SPEED 0
The skip speed is 0.
TLM ILL. AXIS command
No axis or two or more axes were
specified in the automatic tool length
measurement block.
T-CMD IN BLOCK
The T code is in the same block as the
automatic tool length measurement block.
NO T-CMD BEFOR
The T code was not yet specified in
automatic tool length measurement.
TLM ILL. SIGNL
Before the area specified by the D
command or decelerating area parameter
d' the measurement position arrival signal
went on. The signal remains off to the end.
SKIP ERROR (CC)
A skip command was specified during
radius compensation processing.
ILLEGAL PARA.
• G114.1 was commanded when the
spindle synchronization with PLC I/F
command was selected.
• Spindle synchronization was commanded
to a spindle that is not connected serially.
PREPRO S/W ERR
Combining commands that required
pre-reading (nose R offset‚ corner
chamfering corner R‚ geometric I ‚
geometric I B‚ and multiple fixed cycle
commands) resulted in eight or more
pre-read blocks.
search engine
7. List of Alarms
7.10 Program Error
• Specify the skip speed.
• Specify only one axis.
• Specify this T code before the block.
• Specify this T code before the block.
• Review the program.
• Specify a diameter cancel (G40) command'
or remove the skip command.
• Check the program.
• Check the argument of G114.1 command.
• Check the state of spindle connection.
• Reduce the number of commands that
require pre-reading or delete such
commands.
IV - 82
Remedy