Mitsubishi Electric MELDAS C6 Instruction Manual page 4

Always read the specifications issued by the machine manufacturer, this manual,
related manuals and attached documents before installation, operation, programming,
maintenance or inspection to ensure correct use.
Understand this numerical controller, safety items and cautions before using the unit.
This manual ranks the safety precautions into "DANGER", "WARNING" and "CAUTION".
DANGER
WARNING
CAUTION
Note that even items ranked as "
on the situation. In any case, important information that must always be observed is
described.
Not applicable in this manual.
Do not put any startup switch for C6/C64 on GOT's touch key. If a communication fault (including
cable disconnection) occurs between GOT and CNC C6/C64, the communication will be suspended
and the GOT will become inoperative. In this case, even when you release your hands from the
startup switch, CNC will fail to recognize the cutoff of startup signal, which may cause serious
accidents.
1. Items related to product and manual
2. Items related to installation and assembly
Downloaded from ManualsNet.com
Precautions for Safety
When the user may be subject to imminent fatalities or major
injuries if handling is mistaken.
When the user may be subject to fatalities or major injuries if
handling is mistaken.
When the user may be subject to injuries or when physical
damage may occur if handling is mistaken.
For items described as "Restrictions" or "Usable State" in this manual, the instruction
manual issued by the machine manufacturer takes precedence over this manual.
An effort has been made to describe special handling of this machine, but items that
are not described must be interpreted as "Not Possible".
This manual is written on the assumption that all option functions are added. Refer to
the specifications issued by the machine manufacturer before starting use.
Refer to the manuals issued by the machine manufacturer for each machine tool
explanation.
Some screens and functions may differ or may not be usable depending on the NC
version.
Always ground the signal cable to ensure stable operation of the system. Ground the NC unit,
power distribution panel and machine to a one-point ground to establish the same potential.
search engine
CAUTION", may lead to major results depending
DANGER
WARNING
CAUTION