Operation Method For The Auxiliary Axis Adjustment Function - Mitsubishi Electric MELDAS C6 Instruction Manual

[T] Origin set
Operation status

2.7.10.3 Operation Method for the Auxiliary Axis Adjustment Function

The following shows the operation method for the auxiliary axis adjustment function.
(1) Operating conditions for the operation adjustment mode
(a) The operation adjustment function is a function of the AUXILIARY AXIS MONITOR screen.
Change to the AUXILIARY AXIS MONITOR screen when using this function.
(b) Confirm the following items before entering the auxiliary axis adjustment mode. The auxiliary axis
adjustment mode cannot be used if the following conditions are not fulfilled.
1) There must not be the "Y03 AUX AMP UNEQU." error. (The MR-J2-CT must be connected,
2) The OPERATION ADJUSTMENT MODE VALID signal (R3684 bit0) must be ON.
3) The SERVO OFF signal and INTERLOCK CANCELED signal (R3603/R3609/R3615/R3621/
4) The OPERATION START signal (R3602/R3608/R3614/R3620/R3626/R3632/R3638 bit 0)
(c) Do not turn ON the OPERATION START signal command during the auxiliary axis operation
adjustment mode. The MR-J2-CT may make unanticipated movements when the operation
adjustment mode is canceled.
(2) Validating/canceling the operation adjustment mode
Carry out the following operation to validate the auxiliary axis adjustment function.
Operation key: J
Conversely, carry out the following operation to cancel the operation adjustment mode.
Operation key: J carries out a screen changeover operation.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Item
This shows the ON/OFF status of the origin point setting.
This item is highlighted when selected.
The operation status is displayed in the column to the right of the item.
Normal Rot.
Reverse Rot.
Stop
and in a usable state.)
R3627/R3633/R3639 bits 0, 4, 5) must be OFF.
must be OFF.
search engine
2.7 Diagnosis
Display details
: Rotation is in the forward direction.
: Rotation is in the reverse direction.
: The auxiliary axis is stopped.
I - 220