Plc Switch; Plc Switch On And Off Operation - Mitsubishi Electric MELDAS C6 Instruction Manual

2.2.5 PLC Switch

When the menu key
The control signals for operation are assigned by using user PLC. The PLC-SWITCH screen
enables you to set each control signal to on or off. (A maximum of 32 signals)
This screen is created with the user
PLCs, so each screen will differ. Refer
to the instruction manual issued by the
machine maker.

2.2.5.1 PLC Switch ON and OFF Operation

Set the number of the switch to be set to on in # ( ) and press the
switch is set to the up position.
In this state, the switch function becomes effective and is controlled.
To set OPTIONAL STOP to ON,
The switch mark of OPTIONAL STOP
is set to the up position, indicating the
switch on state.
To set the up-position switch (ON state) to OFF (down-position switch), set the number of the
ON-state switch in # ( ) and press the
The PLC switch names (message display) and the function to reverse selected message display
are prepared by using user PLC. These vary depending on the machine manufacturer.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
PLC-SW
Set 4 in # ( ).
Press the key.
INPUT
search engine
2.2 Monitor
is pressed, the PLC SWITCH screen is displayed.
key.
INPUT
I - 39
key. The mark of the
INPUT