Tool Life Data Display And Setting (Tool Life Data Screen - Mitsubishi Electric MELDAS C6 Instruction Manual

(Refer to "2.3 (I) Tool Offset
(L system)" for L system.
2.3.3.3 TOOL LIFE Data Display and Setting (TOOL LIFE Data Screen Page 2)
(1) Data display
Set G123 in # (
Press the
(2) Data registration
Set G
the
Set necessary data of TOOL NO.
to USED in the corresponding
parenthesis pairs in the ascending
order of the (#) numbers, then
press the
(Note 1) If TOOL NO. and ST (status) are not set, setup data becomes invalid.
(Note 2) A single tool cannot be registered in more than one group.
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
When the menu key NEXT
described), the TOOL LIFE screen is displayed.
The data in the group previously set is displayed. If no data is set, the screen is displayed with
blank in the data area.
).
INPUT
key.
Select TOOL LIFE data screen for the
group in which data is to be registered.
in # ( ), then press
INPUT key.
INPUT
key.
search engine
2.3 (II). Tool Offset (M system)
is pressed on the HEAD, NEXT, GROUP list screen (previously
The tool data registered in group 123 is displayed in the
registration order. If the data exceeds one screen, the
remaining data can be seen by using the
key.
The data setting number incremented by one is set in #
( ).
I - 92
NEXT