I/O Device Param - Mitsubishi Electric MELDAS C6 Instruction Manual

2.4.3.2 I/O Device Param

Parameters for up to five types of input/output devices can be set in DEV <0> to <4>.
#
9101
9102
9103
9104
9105
9106
9107
9108
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Items
DEVICE NAME Set the device name corresponding to the device No.
Set a simple name for quick identification.
Use alphabet characters, numerals and symbols to set a name within 3
characters.
BAUD RATE Set the serial communication speed.
STOP BIT Set the stop bit length used in the start-stop system.
PARITY CHECK Specify whether to add the parity check bit to the data during
communication.
EVEN PARITY Specify the odd or even parity when it is added to the data.
CHR. LENGTH Set the length of the data bit
TERMINATOR
TYPE
HAND SHAKE Specify the transmission control method.
The method will be no procedure if a value other than the above is set.
search engine
2.4 Parameters
TERMINATOR TYPE
1: 9600bps 5: 600bps
2: 4800bps 6: 300bps
3: 2400bps 7: 150bps
4: 1200bps
1: 1 bit
2: 1.5 bits
3: 2 bits
0: Parity bit not added
1: Parity bit added
0: Odd parity
1: Even parity
0: Data is 5 bits
1: 6 bits
2: 7 bits
3: 8 bits
0: Read is ended at the EOR code.
1: Read is ended at the EOB code.
1: RTS/CTS method (This method can be used only for S102.)
2: No procedure (No handshaking)
3: DC code method
I - 106
EIA OUTPUT
DR OFF
DATA ASCII
INPUT FORM
Details
7
EIA [
code
]
#
∗
=
:
$
!