Rapid Traverse Feed Mode - Mitsubishi Electric MELDAS C6 Instruction Manual

4.3 Rapid Traverse Feed Mode

The rapid traverse feed mode enables the machine to be moved consecutively at rapid traverse
feedrate manually.
The rapid traverse feedrate can be changed in four steps by using the RAPID TRAVERSE
OVERRIDE switch. The rapid traverse feed mode is started by using the FEED AXIS SELECT
switch.
(Note 1) Refer to the manual issued by the machine manufacturer for the rapid traverse feedrate.
(Note 2) See Section 5 for the RAPID TRAVERSE OVERRIDE switch.
Operation procedure
Using the MODE SELECT switch,
select the rapid traverse feed mode.
Using the RAPID TRAVERSE
OVERRIDE switch, set any desired
override value.
To move the controlled axis, turn on
the FEED AXIS SELECT switch. The
controlled axis is moved while the
switch is turned on.
When the switch is turned off, the
controlled axis stops with deceleration.
(Note 1) The override value set by using the CUTTING FEED OVERRIDE switch is not effective
Downloaded from ManualsNet.com
4.3 Rapid Traverse Feed Mode
for the rapid traverse feedrate; when the override value is 0%, the controlled axis does not
move.
search engine
4. Operation Mode
MODE SELECT
M D I
HANDLE
INCRE-
MENTAL
RAPID TRAVERSE OVERRIDE
+X
-X
II - 9
MEMORY
RAPID
TRAVERSE
JOG
REFERENCE
PO INT RETURN
100
50
25
1
%
FEED AXIS SELECT
+4
+Y +Z
-Y -Z
-4