Mitsubishi Electric MELDAS C6 Instruction Manual page 306

Menu
Setting
TIME
/Div
Trigger
Downloaded from ManualsNet.com
3. Screen Operation When Using a Panel Computer
3.7 Realtime Wave Screen (For only the panel computer)
Offset Set the vertical axis' basic position. (-999999999 to 999999999)
The setting can be changed with
with
P-P 0 to 999999999
Displays the difference between the maximum value and the minimum
value.
Set the horizontal axis (display range) scale. When this menu is pressed, the display
range in the waveform display area will be highlighted.
The setting can be changed with
scale can be set in the range of 0 to 9999.
Pressing Trigger button turns the waveform display to the next screen, that is, Trigger
condition setting screen.
On this screen, select the setting item by touching the item to be set or by using the
UP/DOWN cursor buttons.
Trigger button cannot be used on the screen transit from NC Alarm Guidance Tool.
search engine
Details
.
. The setting digit can be selected with
Pre-trigger value
I - 291
. The setting digit can be selected
Trigger Channel
Trigger Mode
single
Level
Trigger Level
Trigger edge type
On → Off
Stop type
X device
Stop device address
Off → On
Stop edge
. The