Mitsubishi Electric MELDAS C6 Instruction Manual page 448

T03 BLOCK STOP
Error No.
0301
0302
0303
0304
0305
0306
0310
Downloaded from ManualsNet.com
Details
SNGL BLK ON (Single block on)
The SINGLE BLOCK switch on the
machine operation panel is ON.
User macro stop
Block stop was commanded in the user
macro program.
Mode change
The automatic mode changed to another
automatic mode.
MDI completion
The last block of MDI was completed.
Block cutting start interlock
The interlock signal that locks the block
cutting start is entered.
Block cutting start interlock
The interlock signal that locks the block
cutting start is entered.
Offset change of inclined Z-axis during
program operation
Whether to validate the offset of the
inclined Z-axis switched during program
operation.
search engine
7. List of Alarms
7.2 Stop Codes
This indicates that automatic operation stopped after executing
one block of the program.
• Automatic operation can be resumed by
turning the CYCLE START switch ON.
• The automatic operation can be
resumed by turning ON the cycle start
switch.
• Return to the original automatic
operation mode‚ and resume automatic
operation by turning the CYCLE START
switch ON.
• Set MDI again‚ and turn the CYCLE
START switch ON to resume MDl
operation.
• Check the sequence program.
• Check the sequence program.
• Automatic operation can be restarted by
turning on the cycle start switch.
IV - 32
Remedy