Local Variable Data Display - Mitsubishi Electric MELDAS C6 Instruction Manual

<INVALID>
FEED-HOLD
OVERRIDE
EXACT
SNGL-BLOCK
MST-FIN

2.2.7.1 Local Variable Data Display

(1) When local variable #1~#32 command exists in user macro or argument specification is made
(Example)
When the following machining
program is executed and user macro
subprogram is called, data as shown
in the right is displayed on the page
of local variable display level (1):
G65 P1 A1. B2. C3. ;
Downloaded from ManualsNet.com
2. Screen Operation of A985GOT
Display item
in user macro subprogram call, if the block is executed, the execution result is displayed.
search engine
2.2 Monitor
This indicates the modal state of the operation control status by
the #3003, #3004 command.
FEED-HOLD : Is displayed when command is programmed
with #3004 bit 0 set to 1, indicating that feed
hold is invalid.
OVERRIDE : Is displayed when command is programmed
with #3004 bit 1 set to 1, indicating that cutting
override is invalid.
EXACT : Is displayed when command is programmed
with #3004 bit 2 set to 1, indicating that the G09
(block deceleration check) command is invalid.
SNGL-BLOCK : Is displayed when command is programmed
with #3003 bit 0 set to 1, indicating that block
stop is invalid.
MST-FIN : Is displayed when command is programmed
with #3003 bit 1 set to 1, indicating the state of
proceeding to the next block without waiting for
the MST command completion signal.
I - 44
Explanation