Table of Contents
Advertisement
a
2
This picture shows the procedure to attach the
liquid light guide. The same procedure applies
when attaching the mercury lamp housing.
92
92
8
a
2
b
4
Attaching the light source for reflected light
illumination
Attaching the LED illumination
1
Loosen the mounting screw a (2 positions) on the microscope frame
using an Allen screwdriver.
Be careful, if the mounting screw is loosened too much, it
NOTE
may be come off.
2
Insert the reflected LED light source or the liquid light guide adapter
into the light source mounting hole of the microscope frame until it
touches the end.
When attaching the reflected LED light source, attach
NOTE
it so that the cable for the reflected LED light source
comes to the right side when looking from the back of the
microscope frame.
3
Tighten the mounting screw a of the microscope frame (2 positions)
using the Allen screwdriver.
4
Connect the cable to the connector on the back of the microscope
frame. For details, see "Connecting the cables" (P.96).
Attaching the liquid light guide or mercury lamp housing
In order to attach the liquid light guide or the mercury
NOTE
lamp housing, the optional adapter (MX-HGAD) is required.
1
Loosen the clamping screws a (2 positions) of the microscope frame
using the Allen screwdriver.
2
Insert the adapter (MX-HGAD) in the light source mounting hole of the
microscope frame until it touches the end, and tighten the mounting
screw a (2 positions).
3
Loosen the mounting screw b (2 positions) of the adapter (MX-HGAD)
using the Allen screwdriver.
4
Insert the liquid light guide adapter into the adapter (MX-HGAD) until
it touches the end, and tighten the mounting screw b (2 positions).
For procedures to attach the mercury lamp housing, see "Replacing
the mercury burner" (P.70). After the mercury lamp housing is attached,
perform the centering of the mercury burner.
Attaching the mercury burner
For attaching procedures, see "Replacing the halogen bulb" (P.68).
Advertisement
Table of Contents
