Table of Contents
Advertisement
CAUTION - Carrying the product -
a
b
Handling Precautions
· This product is a precision instrument. Handle it with care and avoid subjecting it to a sudden or severe
NOTE
impact.
· Never disassemble any part of the product. Otherwise, failure may result.
· Do not use the product in areas where it may be subjected to direct sunlight, high temperature and/or
humidity, dust or vibrations.
(For conditions of operating environments, see "8 Specifications" on page 82.
· Before attaching or detaching the units other than the MIX slider for reflected light observation
(U-MIXR), set the main switch of the microscope to
Remove samples and attached units.
Be sure to remove the samples and various units such as observation
tube, lamp housing, stage, etc. before carrying the microscope.
If keeping units attached, the weight is increased and the risk of dropping
the microscope increases.
Hold the holding part and the carrying rod of the microscope
by two people.
c
1. Insert carrying rods a and b provided with microscope frame firmly
into the left and right side panels respectively.
2. One person holds the carrying rod b and the front holding section c
a
, and the other person holds the carrying rod a and the rear holding
section d to carry the microscope carefully.
3. After movement, remove the carrying rods and either allow the user to
keep them in a safe place or attach them to screw holes (2 positions)
on the rear of the microscope as shown in the lower-left picture. Attach
the screw hole caps provided with microscope frame to the screw
holes left by removing the carrying rods.
Do not slide on the top surface of the table.
Do not move the microscope by sliding it on the top surface of the table.
The rubber legs may be damaged.
If you need to pack this product for shipping to a distant location,
etc., the dedicated transport tools and packaging materials are
necessary. Be sure to contact Olympus for assistance.
(OFF)
.
MX63/MX63L
7
7
Advertisement
Table of Contents
