Table of Contents
Advertisement
6-5 Replacing the filter
The filters are very hot immediately after use. Make sure that the filters are cooled down sufficiently
CAUTION
before replacing the filters.
2
a
Light source side
3
4
a
c
The arbitrary filter with the following size can be inserted to the empty
slider (U-25).
1
Set the display surface of the empty slider facing down and the surface
attached with the cover facing up.
2
Insert the precision screwdriver in the notch a of the cover diagonally,
and raise and slide the cover with the precision screwdriver to open
the cover.
3
Insert the arbitrary filter in the filter mounting hole b of the slider.
NOTE
b
4
Insert the precision screwdriver in the notch a , and raise and slide the
cover with the precision screwdriver to return the cover to the original
position. At this time, slide the cover under the tabs (6 positions) c
until the "clap" sound is heard.
Diameter
Ø25 mm
Thickness
2.6 mm or less
If the orientation of the filter to use is specified, insert the
filter so that the filter surface of the light source side faces
up.
MX63/MX63L
75
75
Advertisement
Table of Contents
