Proper Selection Of The Power Supply Cord - Olympus MX63 Instructions Manual

13

Proper selection of the power supply cord

If no power supply cord is provided, please select the proper power supply cord for the equipment by referring to
"Specifications" and "Certified Cord" below:
Caution : In case you use a non-approved power supply cord for Olympus products, Olympus can no longer
warrant the electrical safety of the equipment.
Voltage rating
Current rating
Temperature rating
Length
Fittings configuration
A power supply cord should be certified by one of the agencies listed in Table 1 , or comprised of cordage marked with
an agency marking per Table 1 or marked per Table 2. The fittings are to be marked with at least one of the agencies
listed in Table 1. In case you are unable to buy locally the power supply cord which is approved by one of the agencies
mentioned in Table 1, please use replacements approved by any other equivalent and authorized agencies in your
country.
Country Agency
Argentina IRAM
Australia SAA
Austria ÖVE
Belgium CEBEC
Canada CSA
Denmark DEMKO
Finland FEI
France UTE
Germany VDE
Ireland NSAI
Specifications
125 V AC (for 100-120 V AC area) or, 250 V AC (for 220-240 V AC area)
6 A minimum
60 ˚C minimum
3.05 m maximum
Grounding type attachment plug cap. Opposite terminates in molded-on IEC
configuration appliance coupling.
Table 1 Certified cord
Certification mark
Italy
Japan
Netherlands
Norway
Spain
Sweden
Switzerland
United
Kingdom
U.S.A.
Country Agency
IMQ
JET
KEMA
NEMKO
AEE
SEMKO
SEV
ASTA
BSI
UL
MX63/MX63L
Certification mark
107 107