Olympus MX63 Instructions Manual page 9

CAUTION - Electric safety -
Always use the power cord provided by Olympus.
If the proper the power cord and cables are not used, the electric safety and the EMC (Electro-Magnetic Compatibility)
performance of the product cannot be assured. If no power cord is provided, please select the proper power cord by
referring to the section "Proper selection of the power cord" at the end of this instruction manual.
Always connect the ground terminal.
Connect the ground terminal of the power cord and that of the power outlet. If the product is not grounded, our
intended electric safety and EMC performance of the product cannot be assured.
Do not use the product in close proximity to the sources of strong electromagnetic radiation.
Proper operation may be interfered. The electromagnetic environment should be evaluated prior to operation of the
product.
Disconnect the power cord in case of emergency.
In case of emergency, be sure to unplug the power cord from the power cord connector on the product or from the
wall power outlet. Install the product at the location where you can reach the power cord connector or the power outlet
at hand to disconnect the power cord quickly.
This product is designed with intension to be used in the industrial environment for the EMC performance. Using this
equipment in the residential environment may affect other equipment.
CAUTION - LED (light emitting diode) -
Do not look directly at the light from the LED unit for a long time.
If you feel that the light from LED unit is too bright during observation, adjust the light intensity using the brightness
control knob before continuing the observation. The LED built in this product is basically eye-safe. However, do not
look directly at the light from the LED unit for a long time, since it may cause damage to your eyes.
Do not look directly at the light coming out from the objective or the specular reflection light from the
sample.
Do not look directly at the light coming out from the objective for a long time, since it may cause damage to your eyes.
Do not expose your skin to the light coming out from the objective for a long time.
If your skin is exposed to the light coming out from the objective for a long time, you may get burned.
a
Do not press the micro switch of the MIX slider for reflected
light observation (U-MIXR) with your finger.
If you press the micro switch a of the MIX slider for reflected light
observation with your finger, the MIX slider for reflected light observation
may emit the light.
Do not insert the MIX slider for reflected light observation
(U-MIXR) upside down.
Do not insert the MIX slider for reflected light observation upside down.
Otherwise, the light coming out from the MIX slider for reflected light
observation enters your eyes through the eyepiece and your eyes may
be damaged.
MX63/MX63L
3 3