Table of Contents
Advertisement
a
b
a
c
d
4
When the light source is combined
1
Rotate the light intensity adjustment dial a of the light source
(U-HGLGPS) to adjust the light intensity. The light intensity can be
adjusted in 7 levels. The number indicates the percentage (0 to 100%)
of each light intensity when the maximum light intensity is 100%.
Rotate the light intensity adjustment dial slowly by one level
TIP
at a time.
For details of the light source (U-HGLGPS), refer to the
instruction manual provided with the unit.
5
Using the LIM/SET switch
What is LIM function?
LIM stands for "Light Intensity Manager". By storing the arbitrary
brightness per each objective or observation method in advance, this
function sets the stored brightness automatically when the objective or
the observation method is selected.
Procedure to store the brightness
1
Press the LIM switch a to set the "Store" mode. (LIM switch a is OFF.)
2
Select the brightfield observation method. For procedures to select
the observation method, see "3-3 Selecting the observation method
(BF/DF)" on page 25.
3
Press the objective selection button on the front panel b to engage
the objective with low magnification in the light path and bring the
sample into focus.
4
Rotate the brightness control knob c to set the appropriate brightness
easy to see.
5
Press the SET switch d to store the current brightness in the memory
of this system.
6
Change the objective and preform
brightness for all objectives attached.
7
Change the observation method and perform
appropriate brightness for all observation methods which can be set.
MX63/MX63L
and
. Store the appropriate
4
5
3
to
6
. Store the
33
33
Advertisement
Table of Contents
