Table of Contents
Advertisement
b
a
c
d
Layout of the cable for MIX slider for reflected light observation
1
Attach the cable holders at 2 positions ( a , b ) on the side surface
of the microscope frame.
The cable holders (3 pcs.) are provided with the cable for MIX
TIP
slider (U-MIXRCBL).
2
Open the cable holder a and b , put the cable for MIX slider for
reflected light observation (U-MIXR) into the cable holder, and close
the cable holder.
If you disconnect the connector from the MIX slider for
TIP
reflected light observation, store the cable in the cable holder
as shown in c .
When the connector is disconnected, the indicator d of the
MIX slider for reflected light observation turns OFF.
Indicator of MIX slider for reflected light observation
When the connector is connected
When the connector is not connected
MX63/MX63L
Turns ON
Turns OFF
97
97
Advertisement
Table of Contents
