Table of Contents
Advertisement
10
Assembly
10-1 Assembly diagram
The numbers in the following diagram represent the order to attach each unit.
The units shown in the diagram are typical units. For units which are not described below, contact Olympus or refer to the
latest catalogs.
Before assembling the microscope, remove dust and dirt from the mount of each unit and assemble carefully
NOTE
to prevent from scratches.
The procedures to assemble the units shown by
Assemble the units using the Allen screwdriver (opposite side: 3 mm
TIP
) provided with the microscope frame. Do not use the Allen wrench for purposes other than attaching the stage.
MIX slider for reflected light
observation
DIC slider
Breath shield
3
Brightfield/
darkfield
objective
Holders
(See page 14, 15)
Stage
1
88
88
Eyepiece
7
Revolving nosepiece
4
9
5
Brightfield
(Transmitted light
objective adapter
Brightfield/darkfield
Including transmitted
objective
2
numbers are described on the next page and after.
Digital camera
Camera adapter
Observation tube
Intermediate
6
attachment
Microscope frame
MX63L-F
MX63-F
illumination unit)
light illumination unit
Analyzer
Polarizer
) and the Allen wrench (opposite side: 3mm
Reflected LED
lamp housing
8
Power cord
12
Light guide
10
Filters
Hand switch
Tools (provided with microscope frame)
Allen screwdriver (3 mm)
Allen wrench (3 mm)
Tool holder
Light sources other than LED
(See page 92.)
Light source
Advertisement
Table of Contents
