Replacing The Filter - Olympus GX53 Instructions Manual

6-5 Replacing the filter

Light source side
4
c
54
2
a
3
b
a
The filters become very hot immediately after use. Make
CAUTION
sure that the filters are cooled down sufficiently before
replacing the filters.
Attaching the arbitrary filter
The arbitrary filter of the following size can be inserted to the empty slider
(U-25).
Diameter
Thickness
1
Set the display surface of the empty slider facing down and the surface
attached with the cover facing up.
2
Insert the precision screwdriver in the notch a of the cover diagonally,
and raise and slide the cover with the precision screwdriver to open
the cover.
3 Insert the arbitrary filter in the filter mount hole b of the slider.
If the orientation of the filter to use is specified, insert the
NOTE
filter so that the filter surface of the light source side faces
up.
4
Insert the precision screwdriver in the notch a , and raise and slide the
cover with the precision screwdriver to return the cover to the original
position. At this time, slide the cover under the tabs (6 positions) c
until the "clap" sound is heard.
Ø 25 mm
2.6 mm or less