Mitsubishi Fuso CANTER Owner's Handbook Manual page 73

3. Check whether the
nates or not.
Z21164
•
When the
nate
Vehicles with a DUONIC system: While holding
down the brake pedal, turn the starter switch to
the "START" position to start the engine.
Manual transmission vehicles: While holding
down the brake pedal, depress the clutch pedal
and turn the starter switch to the "START"
position to start the engine.
•
When the
Z21165
Wait until the indicator lamp goes out;
Vehicles with a DUONIC system: While holding
down the brake pedal, turn the starter switch to
the "START" position to start the engine.
Manual transmission vehicles: While holding
down the brake pedal, depress the clutch pedal
and turn the starter switch to the "START"
position to start the engine.
NOTE:
•
If the engine is difficult to start after the
cator lamp has gone out, there may be a problem
with the engine preheating system. Have the
vehicle inspected by an authorized MITSUBISHI
FUSO distributor or dealer.
•
In cold weather, the idling speed may increase
immediately after starting the engine. The idling
speed decreases to the appropriate level when
the coolant temperature rises sufficiently.
4. Release the starter switch when the engine has
started.
If you are not going to start the vehicle immedi-
ately, release the pedal.
5. After the engine has started, let it warm up for 1
to 2 minutes.
indicator lamp illumi-
indicator lamp does not illumi-
indicator lamp illuminates
Engine idling speed
650 rpm
5-7
indi-
P. 5-9