Mitsubishi Fuso CANTER Owner's Handbook Manual page 407

CAUTION
•
Install the battery securely in position. If it is
left loose, shocks and vibrations from road
surface could damage the battery case and
electrode plates, shortening battery life.
•
If the battery needs to be charged, remove it
from the vehicle and remove the caps where
possible before starting the procedure. If it is
charged in the vehicle owing to unavoidable
circumstances, be sure to disconnect the
negative (–) battery cable.
NOTE:
Follow the correct procedure when jump starting a
vehicle with a dead battery by connecting it to a live
battery using a booster cable.
6 Battery removal and installation
Type 1 <vehicle without battery equalizer>
WARNING
•
When disconnecting the battery cables,
disconnect the (–) cable first. When con-
necting the battery cables, connect the (–)
cable last. If you accidentally touched the
(+) terminal and the vehicle body with a
tool with the (–) cable connected to the
battery, a dangerous short circuit could
occur.
•
Store any used battery in a place where
children cannot touch it. Leaking fluid
could otherwise cause burns and blind-
ness.
CAUTION
The urea dosing system continues to operate
for about 2 minutes after the starter switch has
been put in the "LOCK" position. Wait for at
least 2 minutes before disconnecting the bat-
tery.
12-105
P. 13-33