Mitsubishi Fuso CANTER Owner's Handbook Manual page 335

Quantity required:
Quantity
required
3.1 Replacement
1. Place a container under the drain plug
2. Remove inspection plug
the oil flow out.
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take
care to avoid being scalded when draining
hot oil. Give the oil time to cool before drain-
Z21739
ing it.
NOTE:
•
Oil removal is quicker if performed not so long
after the vehicle has been stopped and while the
oil is still warm.
•
Do not confuse the transmission oil inspection
plug
fluid inspection plug and drain plug
located nearer to the front of the vehicle than the
transmission oil inspection plug and drain plug.
3. The drain plug is fitted with a magnet. Wipe off
any metal particles sticking to the magnet.
Z21759
Replace the plug's gasket with a new one, coat
the threads on the plug with sealant, and then
install and tighten the plug.
Sealant
Tightening torque
4. After transmission oil has drained out com-
pletely, install and tighten the drain plug.
Approx. 3.5 liters
Plus approx. 0.2 liters for vehi-
cle with standard PTO, or plus
approx. 0.3 liters for vehicle
with large-capacity PTO
and drain plug with the clutch control
ThreeBond 1105
68.6 ± 14.7 N·m
(7.0 ± 1.5 kgf·m)
12-33
.
and drain plug to let
, which are