Mitsubishi Fuso CANTER Owner's Handbook Manual page 337

4.1 Replacement
1. Place a container under the drain plug
2. Remove inspection plug
let the oil flow out.
WARNING
The gear oil is extremely hot immediately
after the vehicle has been operated. Take
care to avoid being scalded when draining
Z12521
hot oil. Give the oil time to cool before drain-
ing it.
NOTE:
Oil removal is quicker if performed soon after the
vehicle has been stopped and while the oil is still
hot.
3. Wipe off any metal particles sticking to the drain
plug. Replace the plug's gasket with a new one,
coat the threads on the plug with sealant.
Sealant
4. After transfer oil has drained out completely,
install and tighten the drain plug.
Tightening torque
5. Add oil through the inspection plug hole until it
reaches the bottom of the hole
Put your finger straightly into the inspection plug
hole after one minute has passed, and check
that the transfer oil surface
ing of the hole.
6. Like with the drain plug, replace the gasket of
the inspection plug with a new one, coat the
threads on the plug with sealant, and then install
and tighten the plug.
Z18456
Sealant
Tightening torque
12-35
.
and drain plug
ThreeBond 1105
68.6 ± 14.7 Nm
(7.0 ± 1.5 kgfm)
.
reaches the open-
ThreeBond 1105
68.6 ± 14.7 Nm
(7.0 ± 1.5 kgfm)
to