Mitsubishi Fuso CANTER Owner's Handbook Manual page 389

3.3 How to remove a wheel
WARNING
•
Under no circumstances should anyone
get under the vehicle when it is supported
only with the jack. The jack could slip out
from under the vehicle. Also, do not
attempt to start the engine when the vehi-
cle is jacked up.
•
Check that the jack is positioned securely.
If the jack slipped out of position, a seri-
ous accident could occur.
•
When the vehicle is to remain jacked up
for a long period, support the frame with
concrete or wooden blocks for safety.
•
When removing the outside tire from a rear
wheel that is installed with single nuts,
make sure the inside tire is not on a
wooden block, etc. Otherwise, a serious
accident could occur since the inside and
outside tires can be removed at the same
time when the wheel nuts are removed.
CAUTION
•
If the vehicle is carrying heavy cargo, unload
it before jacking the vehicle up.
•
When jacking up the vehicle, be sure to
place the jack only in the specified locations
as applying the jack to any point other than
the jacking-up points could damage the vehi-
cle or cause injury.
1. Securely apply the parking brake. Apply chocks
to the front and back (as seen from the side of
the vehicle) of the wheel diagonally opposite the
one that is to be jacked up.
2. Position the jack under the jacking point of the
vehicle and raise the vehicle to a point at which
the tire is still touching the ground.
CAUTION
After raising the vehicle slightly, confirm that
the jack is securely in position.
WARNING
If the jack slipped out of position with the
vehicle fully raised, the vehicle could fall and
cause a serious injury.
12-87