Mitsubishi Fuso CANTER Owner's Handbook Manual page 314

12-12
Simple inspection and service
4 Checking locking of the cab
When the cab is lowered down, the state of locking
should be checked as follows. If incomplete locking
is identified, repeat the cab tilting procedure and
lower once again. If incomplete locking still exists,
never drive the vehicle and contact your nearest
authorized MITSUBISHI FUSO distributor or dealer.
1. Confirm that the latch
the pin
move when it is pulled.
2. Confirm that the cab does not rise up when lever
C
Z18464
3. Turn the starter switch to the "ON" position, then
make sure the multi-information display does
not indicate the
WARNING
Do not drive the vehicle while the multi-infor-
mation display is showing
could cause the cab to rise. If the multi-infor-
mation display is showing
Z20948
again.
. Also confirm that lever B
is pulled.
warning.
is fully engaged with
does not
. Vibration
, tilt the cab