Mitsubishi Fuso CANTER Owner's Handbook Manual page 384

12-82
Simple inspection and service
1.1 Before jacking up the vehicle
•
Park the vehicle on a flat, hard surface. Pull the
parking brake all the way on. If your vehicle has
a manual transmission, place the gearshift lever
in the neutral position. If your vehicle is
equipped with the DUONIC system, place the
gearshift lever in the "P" position.
•
Be sure to stop the engine.
•
If you get a flat tire while on the road and need
to change it on the spot, pull up your vehicle in a
safe place where it will not block traffic, and
cause your hazard warning lamps to flash and
use a red or white flag or cloth to give warning to
passing vehicles.
•
Have all passengers get out of the vehicle.
•
Block with a chock the tire diagonally opposite to
the tire to be replaced.
Example:
Block the left front tire if the right rear tire is to be
replaced.
•
Prepare the spare tire.
2 Using the hydraulic jack
2.1 To raise
1. If the place you wish to apply the jack to is too
high, extend the ram head
terclockwise.
Z10810
2. Using the slit at the end of the wrench handle
(onboard tool), turn the release valve
wise to screw it in.
Z10821
P. 12-98
by turning it coun-
clock-