Mitsubishi Fuso CANTER Owner's Handbook Manual page 351

6. Disconnect the sensor connector
after pulling up the connector's lock knob
then pulling out the top part
Z21455
7. Disconnect the connector
case
connector toward you to release the lock
then pulling the connector directly upward.
Z21456
8. Remove the fuel filter case by turning it counter-
clockwise using the special tool
available). Let the fuel inside the case drain out.
Z21580
9. Remove the filter element
pulling it straight upward.
10. Replace the O-ring
with a new one. After applying a light coat of
engine oil to the new O-ring, install it on the fuel
filter case.
CAUTION
•
Remove and install the filter element
parallel with the axis of the filter case. Other-
Z21459
wise, the sensor
become damaged.
•
Use only the O-ring supplied with a new
replacement filter element.
. Do this by pulling the bottom part of the
of the fuel filter case
inside the case could
12-49
. Do this
and
of the connector.
from the fuel filter
and
(separately
out of the case by
in