Mitsubishi Fuso CANTER Owner's Handbook Manual page 137

NOTE:
Parked DPF regeneration is impossible in the fol-
lowing conditions:
•
Within 10 seconds after starting the engine
(manual transmission vehicles)
•
Within 30 seconds after starting the engine
(vehicles with a DUONIC system)
•
When the coolant indicator shows the tempera-
ture by up to 5 segments (Perform parked DPF
regeneration after warming up the engine.)
•
When the PTO switch is in the "ON" position
(vehicles with a PTO)
•
While the accelerator pedal or brake pedal is
being depressed
•
While the vehicle is moving
•
When the gearshift lever is in any position other
than "P" or "N" (vehicles with a DUONIC system)
•
When the clutch pedal is depressed (manual
transmission vehicles)
When the
during parked DPF regeneration, the idling stop and
start (ISS) system does not operate (vehicles with
idling stop and start (ISS) system).
1. Park the vehicle in a safe place and warm up the
engine.
2. Firmly apply the parking brake and place the
gearshift lever in the neutral position. If your
vehicle is equipped with a DUONIC system,
place the gearshift lever in the "P" or "N" position
and then wait for at least 30 seconds.
3. If your vehicle is equipped with an engine idling
control volume, make sure the engine idling
control volume is in the "AUTO" position.
Z21162 4. If your vehicle is equipped with a PTO, make
sure the PTO is disengaged.
5. With the engine still in operation, continuously
press the "ON" side of the DPF cleaning switch
until the
flashing and shifts to continuous illumination.
The engine will increase its idling speed (to
approx. 1,500 rpm) to start the parked DPF
regeneration. When the parked DPF regenera-
tion is started, the predicted time until comple-
tion of the regeneration is indicated on the multi-
information display. The exhaust brake valve
may also operate during the parked DPF regen-
Z21280
eration.
(amber) indicator lamp is flashing or
(amber) indicator lamp
5-71
P. 8-2
stops