Mitsubishi Fuso CANTER Owner's Handbook Manual page 210

1 Location of control and indicator lamps
Front drive switch
4WD indicator lamp
Free-wheeling hub
Z21993
Z19059
1.1 Front drive switch
The front drive switch is used to select either the
two-wheel drive (2WD) mode that uses only the two
rear wheels as driving wheels or the four-wheel
drive (4WD) mode in which the engine power is
transmitted to all four wheels. Turn this switch "ON"
to select the 4WD mode; turn it "OFF" to select the
2WD mode. The
the 4WD mode is selected.
•
The mode selection can be performed when the
vehicle is stationary and without depressing the
Z21362
clutch pedal.
CAUTION
Make sure that the free-wheeling hubs on both
the front wheels are in the "LOCK" position
when the 4WD mode is selected; in the "FREE"
position, the engine power is not transmitted to
the front wheels.
indicator lamp lights up when
8-13
P. 8-15