Mitsubishi Fuso CANTER Owner's Handbook Manual page 390

12-88
Simple inspection and service
3. Using socket wrench
included in the onboard tool set, slightly loosen
the wheel nuts by turning them in the illustrated
direction. Do not remove the nuts.
For right-hand wheel
For left-hand wheel
NOTE:
•
The wheel nuts on the right-hand wheel are
marked with "R" and have right-hand threads.
Z09304
Those on the left-hand wheel are marked with
"L" and have left-hand threads.
•
If you wish to remove only the outer wheel of
double-nut-type double wheels, you do not need
to loosen the inner wheel nuts.
WARNING
•
Fit the socket wrench securely on the
wheel nut. If fitted improperly, the wrench
will slip off the nut, and could cause injury.
•
Do not loosen the wheel nuts too much or
you could damage the threads.
4. Jack up the vehicle until the tire is just clear of
the ground.
5. Remove the wheel nuts and then the tire.
•
Single wheel (single-nut type)
Remove all of the wheel nuts, then remove
the wheel.
•
Double wheels (single-nut type)
Remove all of the wheel nuts, then remove
the inner and outer wheels at the same time.
•
Double wheels (double-nut type)
First loosen the outer wheel nuts
remove outer tire
loosen inner wheel nuts
square socket end of the wheel nut wrench,
and jack up the vehicle again to remove
inner tire
NOTE:
With single-nut-type double wheels, the inner and
outer wheels can be removed at the same time.
Z09307
and wrench handle
; then lower the jack,
.
and
by using the