When Braking Is Sluggish - Mitsubishi Fuso CANTER Owner's Handbook Manual

7 Step lamp <Vehicles with step lamps>
1. Insert a flat-blade screwdriver into the tab
locations at the bottom end of the lens and
remove the lens by pulling it toward you while
raising it.
2. Pull out the bulb
3. Install the lens by inserting the tabs at the bot-
tom end into the slots and then pushing the
locations of the tabs
lens.
Z09128
8 Replacing other lamps
1. Loosen the screw that secures the lens then
remove the lens.
2. Turn the bulb counterclockwise while pressing it
and remove it.
3. Insert a new bulb and turn it clockwise.
4. Fit the lens, ensuring that the packing is cor-
rectly positioned. If the packing is incorrectly
installed or twisted, water can enter the lamp
and shorten its life. If the packing is dirty, clean
it.
5. Uniformly tighten the screws that retain the lens.
WARNING
•
Never use the parking brake during driving
except in an emergency. Pulling the park-
ing brake lever with full force while driving
could cause the vehicle to topple over.
•
Never continue driving with the brake sys-
tem malfunctioning or leaking fluid.
Depress the brake pedal harder than usual, down-
shift to use engine braking and activate exhaust
braking to stop the vehicle. Apply the parking brake
when necessary. After the vehicle has been brought
into a stop, check parts, then call your nearest
authorized MITSUBISHI FUSO distributor or dealer.
.

When braking is sluggish

13-31
at the top end of the