Mitsubishi Fuso CANTER Owner's Handbook Manual page 448

3 Replacing the bulb of the end out-line
marker lamp <Vehicles with end out-line
marker lamps>
•
Removal
1. Remove the screw
and then slightly raise the rear end of the lens.
2. Push the lens forward to detach the lugs
the front end of the lens from the base, then
remove the lens.
3. Remove the bulb
Z19883
•
Installation
1. Push the new bulb into the socket.
2. Clean the packing
3. Place and hold the lens
installing the screw
4. Push the top of the lens down to engage the
lugs
5. Tighten the screw to within the specified torque
range.
Tightening torque
Z19884
4 Replacing the fog lamp bulb <Vehicles
with fog lamp bulb>
•
Removal
1. Tilt up the cab if it has a tilting mechanism.
2. Remove the cover
clockwise to a stop.
3. Disconnect the bulb connector
4. Disconnect the connector
5. Unhook the spring
Z21141
•
Installation
1. Hold the bulb with the square groove
top (with the circular groove
then align the bulb with the lugs
lamp unit, install it and fix it with the spring
2. Reconnect the connector
3. Reconnect the connector
4. Clean the packing
straighten the packing if it is twisted.
5. Install the cover
clockwise.
6. Lower the cab if it was tilted up.
Z21437
that secures the lens
by pulling it forward.
if dirty.
. Do not tighten the screw.
with the base.
1.0 to 1.2 Nm
(0.10 to 0.12 kgfm)
after turning it counter-
, then pull out the bulb
on the lamp unit and turn it
13-29
on
in position by loosely
.
from the lamp unit.
at the
at the bottom),
on the fog
.
of the bulb.
to the fog lamp unit.
if necessary. Also
.