Mitsubishi Fuso CANTER Owner's Handbook Manual page 395

4
2
1
3
5
1
6
3
4
5
2
Z09311
5. Mount rear dual-wheels as described below.
WARNING
When replacing an outer wheel on a vehicle
whose rear dual-wheels are secured, be sure
to retighten the inner wheel nuts before tight-
ening the outer wheel nuts.
NOTE:
When installing dual wheels, make sure that the air
valve of the inner wheel is not lined up with the air
valve of the outer wheel.
Mount the inner wheel, then jack up the vehicle
again. Set the outer wheel such that the wheel
bolts are located in the centers of the disc
wheel's bolt holes, then tighten the wheel nuts
just enough to eliminate looseness.
Lower the vehicle, then tighten the wheel nuts in
the illustrated sequence. Work through the
sequence two or three times, finally tightening
each wheel nut to the specified torque.
6. If only the outer wheel of the rear dual-wheels is
replaced, retighten the inner wheel nuts to the
specified torque before mounting the outer
wheel.
WARNING
As the vehicle is driven after a wheel has
been replaced, the wheel nuts loosen up
somewhat during the early stages of driving
due to "wear-in." Therefore, it is necessary to
retighten the wheel nuts to the specified
torque after driving 50 to 100 km. Thereafter,
retighten the nuts at regular intervals.
12-93